Repeater Operation; General; Reversed Duplex Mode - Icom IC-V82 Instruction Manual

■ General

When using a repeater, the transmit frequency is shifted from
the receive frequency by the offset frequency. It is convenient
to program repeater information into memory channels.
q Set the receive frequency (repeater output frequency).
w Push [A•
] and [4• ] several times to select "–" or "+."
FUNC DUP
• "–" indicates the transmit frequency is shifted down; "+" indicates
the transmit frequency is shifted up.
• Blinking "–" or "+" indicates the reversed duplex mode is selected
in (p. 58).
SET MODE
ePush [A•
] and [1•
FUNC TONE
subaudible tone encoder, if required.
• " " appears.
• Select the desired subaudible tone frequency, if necessary.
(p. 18)
r Push and hold [PTT] to transmit.
• The displayed frequency automatically changes to the transmit
frequency (repeater input frequency).
• If "OFF" appears, check the offset frequency (see next page for
details) and direction.
t Release [PTT] to receive.
yPush and hold [MONI] to check whether the other station's
transmit signal can be directly received.
] several times to activate the

REPEATER OPERATION

■ Reversed duplex mode

When the reversed duplex mode is selected, the receive fre-
quency shifts.
(Transmit frequency shifts in normal duplex mode.)
Each receive and transmit frequency is shown in the table
below with the following conditions;
IC-V82
Input frequency
Direction
Offset frequency
IC-U82
Input frequency
Direction
Offset frequency
IC-V82
Reversed OFF
Rx freq. 145.30 MHz 144.70 MHz 439.80 MHz 434.80 MHz
Tx freq. 144.70 MHz 145.30 MHz 434.80 MHz 439.80 MHz
q Push [A•
], then push [8•
FUNC
w Push [Y Y ] or [Z Z ] several times until "REV" appears.
e Rotate [VOL] to turn the reversed duplex mode ON or
OFF.
r Push [✱•
] (or [D•
ENT
5
SET MODE
USING
: 145.30 MHz
: – (negative)
: 0.6 MHz
: 439.80 MHz
: – (negative)
: 5 MHz
IC-U82
ON OFF ON
] to enter .
SET SET MODE
]) to exit .
CLR SET MODE
4
5
17