Repeater Call Sign Programming - Icom IC-V82 Instruction Manual

11
DIGITAL MODE OPERATION

■ Repeater call sign programming

Repeater call sign must be programmed for repeater opera-
tion in both digital voice and low speed data communications.
q Push [A•
] and [0•
FUNC
push [Y Y ] or [Z Z ] several times to select the call sign items.
• "R1C" or "R2C" appears for repeater call sign.
w Push and hold [0•
lect the desired call sign channel.
e Push [Y Y ] to select call sign programming mode.
• The 1st digit blinks and channel indication stops blinking.
r Rotate [VOL] to set the desired character or code.
• Push [Z Z ] or [Y Y ] to move the cursor to left or right, respectively.
t Push [Y Y ] to select 2nd digit, then rotate [VOL] to set the
desired character or code.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for programming repeater call sign.
52
] to enter
OPT OPTION SET MODE
] for 1 sec. then rotate [VOL] to se-
OPT
y Push [0•
] to save the call sign.
OPT
u Rotate [VOL] to select an another channel from "C1" to
"C6."
i Repeat steps w to u to program other repeater call sign
channels.
, then
✔ For your information:
Station and/or repeater call sign can be programmed from
Received call record when a call is received.
See page 46 for details.
✔ For your information:
Repeater call sign can be programmed for gateway connec-
tion capabilities at step r for connecting to the another Area
or Zone.
• "G" appears or disappears as the 8th digit when pushing [8•
While using the repeater 2 (other Area or Zone) system, the
repeater 2 setting must be selected ON in
• "R2C" (Repeater 2 call sign) can be programmed or used when
"RP2" (Repeater 2 setting) is set to ON (default).
].
SET
.
OPTION SET MODE