Connecting A Dual Switch Pedal - Kurzweil Artis User Manual

Getting Started
Connecting Pedals
Of course this can be changed by programming, as described in Multi Mode on page 7-1.
The default assignments of the pedals can also be overridden in Global Mode as described
on page 9-6.
If you are not using a Kurzweil switch pedal, make sure it's connected before you turn on
the Artis. This ensures that the pedal will work properly (it might function in reverse—off
when it's down and on when it's up—if you turn on your Artis before plugging in the pedal).
Similarly, don't press any of your switch pedals while powering up, as the Artis verifies each
pedal's orientation during power-up. If you're pressing a pedal, you might cause it to work in
reverse.
See Switch Pedal Problems on page 11-5 if you are having trouble with your switch pedal.

Connecting a Dual Switch Pedal

You can connect a dual switch pedal with a single stereo plug, such as the Kurzweil KFP-2S,
into the SW1 Pedal and SW2 Pedal jacks. Both SW1 and SW2 can support a dual pedal each
allowing up to 4 pedals to be utilized by the Artis. These are enumerated as SW1a, SW1b,
SW2a and SW2b. The Artis will recognize dual pedals that are wired as TS and RS, such as
the KFP-2S.
2-8