Table of Contents
Advertisement
Connecting a Dual Switch Pedal
You can connect a dual switch pedal with a single stereo plug, such as the Kurzweil KFP-2S,
into the SW1 Pedal and SW2 Pedal jacks. Both SW1 and SW2 can support a dual pedal each
allowing up to 4 pedals to be utilized by the Artis SE. These are enumerated as SW1a, SW1b,
SW2a and SW2b. The Artis SE will recognize dual pedals that are wired as TS and RS, such
as the KFP-2S.
The default assignments for the Switch Pedals are summarized in the table on the following
page.
NOTE : It is not recommended to plug CC pedals into the SW
inputs. Due to the flexible switch pedal support, CC pedals
may not operate as expected in these inputs.
Introducing Artis SE
The Rear Panel
7
Advertisement
Table of Contents
