Table of Contents
Advertisement
Local
MIDI
Local+MIDI
If you want to play the Artis, but not send any MIDI information to other MIDI
instruments, then select Local.
If you want to use the Artis strictly as a MIDI controller for the other modules in your
MIDI chain, then select MIDI.
If you want to make use of the Artis's sounds as well as use it as a MIDI controller, then
select Local+MIDI.
Pressing both Previous & Next buttons simultaneously will set this parameter to
Local+MIDI.
Bank Select (BankSelect)
The Bank Mode parameter determines the controller number with which MIDI Bank
change messages are received.
For MIDI Bank change messages, various manufacturers have chosen different MIDI
controller numbers. Most have chosen 0, 32, or both. You can set this parameter to any of
the following three controller IDs:
0
MIDI Bank change messages are sent with controller number 0.
32
MIDI Bank change messages are sent with controller number 32.
0 / 32
MIDI Bank change messages are sent with both controller numbers 0 and 32
Pressing both Previous & Next buttons simultaneously will set this parameter to 0/32.
NOTE : MIDI OUT applies to the 5-pin MIDI OUT and USB ports.
MIDI data is sent only to the Artis sound engine. MIDI Out is disabled
MIDI data is sent only through MIDI Out. The sounds of the Artis are
disabled
MIDI data is sent both to the Artis sound engine and through the MIDI Out.
CAUTION: It is possible to stop all MIDI transmission, in Multi Mode,
if one Destination parameter is set to Local, and the other is set to
MIDI.
Global Mode
MIDI Page
.
.
9-9
Advertisement
Table of Contents
