Table of Contents
Advertisement
Multi Edit Mode
Zone Parameters
Entry Program Change
The Entry Program Change parameter determines whether or not the currently selected
Zone will send a MIDI Program change message when the Multi is loaded. You can set
this parameter to either Off or On. When set to On, the Zone will send a MIDI Program
change message with the Program specified for the MIDI Program parameter.
Pressing both Previous & Next buttons simultaneously will set this parameter to On.
Bank Mode
The Bank Mode parameter determines the controller number with which MIDI Bank
change messages are transmitted. For MIDI Bank change messages, various manufacturers
have chosen different MIDI controller numbers. Most have chosen 0, 32, or both. In the
case of the Kurzweil K2600, it responds to controller 32, but is limited to 100 programs per
bank. Pressing both Previous & Next buttons simultaneously will set this parameter to Ctl
0/32.
You can set this parameter to any of the following:
None
Ctl0
Ctl32
Ctl0/32
K2600
Bend Range Down
The Bend Range Down parameter determines the lower bend of the Pitch Wheel. You can
set this parameter to any value between 0 semitones and 127 semitones, or to Prog, which
uses the Bend Range of the currently selected Program for the Zone. The Bend Range
Down value can be entered numerically, and entering -1 will select Prog.
Pressing both Previous & Next buttons simultaneously will select Prog, which uses the value
that the Program would use in Program Mode.
Bend Range Up
The Bend Range Up parameter determines the upper bend of the Pitch Wheel. You can set
this parameter to any value between 0 semitones and 127 semitones, or to Prog, which uses
the Bend Range of the currently selected Program for the Zone. The Bend Range Up value
can be entered numerically, and entering -1 will select Prog.
Pressing both Previous & Next buttons simultaneously will select Prog, which uses the value
that the Program would use in Program Mode.
8-14
MIDI Bank change messages are disabled.
MIDI Bank change messages are sent with controller number 0.
MIDI Bank change messages are sent with controller number 32.
MIDI Bank change messages are sent with both controller numbers 0 and 32.
MIDI Bank change messages are sent with controller number 32. (K2600 Program
numbers 0-99.)
Advertisement
Table of Contents
