Connecting A Dual Switch Pedal - Kurzweil Artis SE Musician's Manual

Getting Started
Connecting Pedals
If you are not using a Kurzweil switch pedal, make sure it's connected before you turn on the
Artis SE. This ensures that the pedal will work properly (it might function in reverse—off
when it's down and on when it's up—if you turn on your Artis SE before plugging in the
pedal). Similarly, don't press any of your switch pedals while powering up, as the Artis SE
verifies each pedal's orientation during power-up. If you're pressing a pedal, you might cause
it to work in reverse.
See Switch Pedal Problems on page 12-5 if you are having trouble with your switch pedal.

Connecting a Dual Switch Pedal

You can connect a dual switch pedal with a single stereo plug, such as the Kurzweil KFP-2S,
into the SW1 Pedal and SW2 Pedal jacks. Both SW1 and SW2 can support a dual pedal each
allowing up to 4 pedals to be utilized by the Artis SE. These are enumerated as SW1a, SW1b,
SW2a and SW2b. The Artis SE will recognize dual pedals that are wired as TS and RS, such
as the KFP-2S.
2-8