Reset To Factory Default Settings; Fault Reset - Sena SPH10S User Manual

SPH10S
20. RESET TO FACTORY DEFAULT
SETTINGS
1. To restore the SPH10S to factory default settings,
press and hold the Phone Button for 12 seconds
until the LED shows solid red and you hear double
beeps. You will hear a voice prompt saying
"Factory reset".
2. W ithin 5 seconds, press the Jog Dial to confirm
reset. The headset will be restored to factory
setting and switched off automatically. You will
hear a voice prompt saying "Headset reset,
good-bye".
3. If you don't press the Jog Dial within 5 seconds,
the reset attempt is canceled and the headset
returns to stand-by mode. You will hear a voice
prompt saying, "Canceled".
32

21. FAULT RESET

When the SPH10S is not working properly or is in a
faulty status for any reason, you may reset the system
by pushing the pin-hole reset button on the back of the
left headset main unit.
1. Detach the velcro pad inside of the left headset to see
a set-screw on the main module under the ear flap.
2. Turn the set-screw to the left to take the module apart
from the ear flap.