Reset To Factory Default Settings; Fault Reset - Sena SPH10H-FM User Manual

SPH10H-FM
20. RESET TO FACTORY DEFAULT
SETTINGS
1. To restore the SPH10H-FM to factory default
settings, press and hold the Phone Button for 12
seconds until the LED shows solid red and you
hear double beeps. You will hear a voice prompt
saying "Factory reset".
2. Within 5 seconds, press the Jog Dial to confirm
reset. The headset will be restored to factory
setting and switched off automatically. You will
hear a voice prompt saying "Headset reset,
good-bye".
3. If you don't press the Jog Dial within 5 seconds,
the reset attempt is canceled and the headset
returns to stand-by mode. You will hear a voice
prompt saying, "Canceled".
32

21. FAULT RESET

When the SPH10H-FM is not working properly or is in
faulty status for any reason, you may reset by pushing
the pin-hole reset button at the back of the headset main
unit. Insert a paper clip into the reset pin-hole and press
the reset button for a second with light pressure. The
SPH10H-FM will be switched off after which time, you
have to turn the system back on and try again. However,
this will not restore the headset to factory default
settings.