Plug-In Harnesses; Super Bright Led, 2-Pin Plug; Valet/Program Switch, 2-Pin Plug - Directed Electronics Python 3000 ESP Installation Manual

H3/8 GREEN (-) FACTORY SECURITY DISARM
This wire will output a (-) 200 mA pulse whenever the system is disarmed. This output can also be programmed
to provide a (-) pulse when Channel 2 is activated (see Systems Feature Learn Routine section of this guide). This
makes integration of this system into a vehicle with a factory alarm very simple.
H3/9 ORANGE/BLACK (+) GHOST SWITCH INPUT
To enhance security, a secondary disarm input called the Ghost Switch is provided. The unit can be programmed
to accept a certain number of pulses (from 1 to 5) on this wire, and treat this signal as a disarm command. It
works for emergency override, VRS, and Automatic Engine Disable. The wire should be connected to a wire, prefer-
ably selected by the customer, that shows (-) ground at rest when not used and (+)12V when the switch
controlling it is operated. For example, the power window, headlight, or brake wire.
H3/10 BLACK/WHITE (-) IGNITION LOCK SAFETY INPUT
As long as this wire is grounded, the ignition controlled lock feature will be prevented. As soon as the ground is
removed, with the ignition on, the doors will lock. This can be tied to the neutral safety switch, reverse indica-
tor or brake switch wire. If this wire is not connected, the ignition controlled door lock feature will work normally.
H3/11 PINK/BLACK (-) DELAYED ACCESSORY OUTPUT
This wire provides a (-) 200 mA latched output 3 seconds after the ignition is turned on. It will remain active when
the key is turned off, until a door is opened and closed. This can be used in conjunction with a relay to energize
certain circuits in the vehicle that would normally require the key to be turned on, i.e. the radio, power windows, etc.

plug-in harnesses

super-bright LED, 2-pin plug
The super bright LED operates at 2VDC. It plugs into the white port on the side of the unit. Make sure the LED wires
are not shorted to ground as the LED will be damaged. Multiple LED's can be used, but they must be wired in
series. The LED fits into a

valet/program switch, 2-pin plug

The Valet/program switch should be accessible from the driver's seat. It plugs into the blue port on the side of
the unit. Since the system features Remote Valet, day-to-day access to the Valet/program switch is not as impor-
tant, so the switch can be hidden in a location that may not be easily accessible. If using the Ghost Switch only
disarm mode, the switch will only function to put the unit in Valet Mode and to program the unit. Consider how
the switch will be used before choosing a mounting location. Check for rear clearance before drilling a
hole and mounting the switch.
© 2001 Directed Electronics, Inc. Vista, CA
9 / -inch mounting hole. Be sure to check for clearance prior to drilling the mounting hole.
32
/ -inch
9
32
21