Troubleshooting - Brita SAFF-100 User Manual

For optimal use, care and safety
®
• The Brita Faucet Filtration System is not intended to purify water. Do not use with water that is
microbiologically unsafe or of unknown quality without adequate disinfection before or after the
system. Individuals requiring water of special microbiological purity should follow the advice of
their doctor or local health officials regarding the use and consumption of their tap water and
®
Brita water.
• The system and installation must comply with state and local laws and regulations.
• Use with cold water only. Do not run hot water (above 100°F/38°C) through the filter, as it may
damage the filter.
• Do not push filter cartridge release button while filtering water.
• Prior to each use, let water run through the filter for five seconds to activate the filter. If the filter
has not been used for a few days, let the water run for 30 seconds before use.
• For optimal system performance and highest quality filtered water, promptly replace the filter
cartridge when signaled by the filter replacement indicator.
®
• Clean the exterior of the Brita Faucet Filtration System with a damp sponge or soft cloth.
A mild dishwashing liquid may be used. Do not use abrasive cleaners or scouring pads to clean this
product. DO NOT put any parts of this product in the dishwasher.
• Only draw filtered water from filter port. All other water is unfiltered.
®
• Do not use the Brita Faucet Filtration System if incoming tap water exceeds 170°F/77°C.
Very hot water will damage the system. (While most of the newer hot water heaters are preset
to 120°F/49°C, temperatures vary from household to household. If you suspect your water
temperature may be higher than 170°F/77°C, check the setting on your water heater.)
6

TROUBLESHOOTING

You are unable to attach See Step 2 of Installation in Five Easy Steps to determine if you need
the system to your faucet to use an adapter. Check to see that you have correctly inserted the
proper adapter and washer.
Adapters provided do not Call Brita Consumer Services at 1-800-24-BRITA (U.S.) or
fit your faucet 1-800-387-6940 (Canada).
Water leaks or sprays Check to see that you placed the washer between the faucet and
from connection at faucet the adapter. Check to see that the mounting collar is tight and the
threading is aligned with the faucet or adapter threading. Only water
from filter port is filtered. All other water is unfiltered.
Water leaks or sprays Make sure the filter cartridge is locked into place. Water leaking or
from the system itself spraying from system may not be filtered. Only water from filter port is
filtered. All other water is unfiltered.
Flow rate of filtered Remove the system from the faucet and clean the sediment from the
water slows strainer in the mounting collar. If flow rate of filtered water remains
slow, replace filter cartridge. Although Brita
replacement filters have an extra layer to reduce sediment buildup,
very high sediment in your water may cause the system to prematurely
clog before the typical end of filter life. The clogging means that your
®
Brita Faucet Filtration System is removing the sediment from your tap
water. See directions for early filter replacement on page 5.
Filter replacement Remove the filter from the base and press the metal pin a few times
indicator does not reset until the indicator window is entirely green. Then re-insert the filter.
with new cartridge
insertion
® Faucet Filtration System
7