Related Manuals for Network Technologies SE-DVI-2
Summary of Contents for Network Technologies SE-DVI-2
- Page 1 NETWORK 1275 Danner Dr TECHNOLOGIES Aurora, OH 44202 INCORPORATED 2 Port DVI Video Switch Installation and Operation Manual Tel:330-562-7070 Fax:330-562-1999 www.networktechinc.com ® VIDMUX Series SE-DVI-2 MAN068 Rev Date 5/24/2006...
- Page 2 VIDMUX is a registered trademark of Network Technologies Inc in the U.S. and other countries. COPYRIGHT Copyright © 2006 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Introduction... 1 Materials ... 1 Features And Functions ... 1 Installation ... 2 Operation... 3 Troubleshooting... 4 Product Specification... 4 Warranty Information... 4 MAN0068 Rev Date5/24/2006... -
Page 4: Introduction
INTRODUCTION The VIDMUX Series SE-DVI-2 (VIDMUX) is a 2-port DVI video switch that enables two video sources such as a PC or HDTV tuner to share one DVI monitor using DVI-I or DVI-D single-link connectors. The DVI interface technology implements digital signal transmission over the cable to eliminate noise and reduce undesired distortion. -
Page 5: Installation
Connect the video sources to their corresponding DVI ports labeled “VIDEO 1" and/or "VIDEO 2" on the rear panel of the VIDMUX using male-to-male DVI-I cables. DVI-IS-xx-MM DVI-IS-xx-MM HDTV Tuner Rear View of SE-DVI-2 Monitor Video 2 5VDC 1275 Danner Dr Aurora, OH 44202 www.networktechinc.com... -
Page 6: Operation
PC boots up. Otherwise the PC may not properly initialize with the connected monitor. OPERATION Press the input select buttons to switch between video sources. The LED above each button will illuminate to indicate which source is connected to the monitor. -
Page 7: Troubleshooting
NTI VIDMUX Series 2-Port DVI Video Switch TROUBLESHOOTING If the VIDMUX is not working properly, please look for a solution in the list below: PROBLEM: No video at all SOLUTION: Check cable connections on each video source, monitor and the VIDMUX. After reconnecting, if a CPU is the video source, the CPU may need to be re-booted in order to sense the monitor connection.