Table of Contents
Advertisement
Starting the Configuration/Setup Utility program
When you restart the computer for the first time after working with most options, a
message similar to the following might appear indicating that a configuration change
has occurred.
If such a message appears, you are then prompted to start the Configuration/Setup
Utility program to manually update the configuration settings or to confirm and save
the settings that were automatically updated by the system programs.
Note: Depending on the configuration changes that occurred, the error message
If the preceding message does not appear, use the Configuration/Setup Utility
program to configure the computer.
Configuring startup sequence
When the computer is turned on and after it completes loading the BIOS code and
performs POST, it looks for an operating system. The order in which it searches
devices for the operating system is determined by the primary startup sequence or
the automatic startup sequence. After adding new devices to the computer, you
might want to change the startup sequence. You can use the Configuration/Setup
Utility program to configure startup devices.
72
Hardware Maintenance Manual: IBM IntelliStation M Pro Type 6233 and 6850
The following error(s) were detected when the system was started:
162 Configuration Changes Has Occurred
Select one of the following:
Continue
Exit Setup
you see might be different from the one shown here. If the preceding screen
appears, select Continue until you reach the Configuration/Setup Utility
program menu (see "Using the Configuration/Setup Utility program" on page
33.
Advertisement
Table of Contents
