Table of Contents
Advertisement
Configuration
The following configuration programs are provided with the computer:
Configuration/Setup Utility program
SCSISelect Utility program
PXE Boot Agent Utility
Using the Configuration/Setup Utility program
This section provides instructions for starting the Configuration/Setup Utility program
and descriptions of the menu choices that are available.
Starting the Configuration/Setup Utility program
Complete the following steps to start the Configuration/Setup Utility program.
1. Turn on the computer and watch the monitor screen.
2. When the message Press F1 for Configuration/Setup displays, press F1.
3. Follow the instructions that appear on the screen.
© Copyright IBM Corp. 2002
The Configuration/Setup Utility program is part of the BIOS code that
comes with the computer. You can use this program to configure serial and
parallel-connector assignments, change the drive startup sequence, set the
date and time, set passwords, and set the chassis-intrusion alert. See
"Using the Configuration/Setup Utility program" for more information.
The SCSISelect Utility is a built-in program that enables you to configure
the devices that are attached to the SCSI adapter (on some models). Use
this program to change default values, resolve configuration conflicts, and
perform a low-level format on a SCSI hard disk drive. See "Using the
SCSISelect Utility program (some models)" on page 36 for more
information.
The Preboot eXecution Environment (PXE) Boot Agent Utility program is
part of the BIOS code that comes with the computer. You can use this
program to select operating-system wake-up support and to set menu wait
times. For information on how to start this utility, see "Using the PXE Boot
Agent Utility program" on page 38.
33
Advertisement
Table of Contents
