Table of Contents
Advertisement
v Show setup prompt
v Setup time wait menu
v Legacy OS wake up support
Notes:
1. Use the default setting for Advanced Configuration and Power Interface (ACPI)
2. If the computer is running a non-ACPI operating system, you must set this
3. When using a non-ACPI operating system, do not send a wake up packet to the
BIOS levels
An incorrect level of BIOS can cause false error and unnecessary FRU
replacement. Use the following information to determine the current level of BIOS
installed in the computer, the latest BIOS available for the computer, and where to
obtain the latest level of BIOS.
v Current Level BIOS information
v Sources for determining the latest level BIOS available
v Sources for obtaining the latest level BIOS available
To update (flash) the BIOS, see "Flash (BIOS/VPD) update procedure" on page 40.
Select this choice to either display the PXE setup prompt or disable it. Disable is
the default setting.
When this choice is enabled, the prompt Press Ctrl+S to enter the setup menu
appears on the screen under the initializing prompt.
Select this choice to set the amount of time (in seconds) that the system will
pause during initialization for a Ctrl+S input.
– 2 seconds (Default)
– 3 seconds
– 5 seconds
– 8 seconds
Select this choice to enable or disable the operating system wake-up support.
– Disabled (Default)
– Enabled
aware operating systems, such as Windows 2000 and Windows NT.
selection to Enable to use the Wake-on-LAN support.
computer while it is turned on.
Run the Configuration Utility to determine the level of BIOS installed.
1. IBM Home Page, Support
http://www.ibm.com/support
2. PC PartnerInfo-Technical Database (CTSTIPS.NSF)
3. HelpCenter
4. Levels 1 and 2 Support
5. RETAIN
1. IBM Home Page, Support
http://www.ibm.com/support
2. PC PartnerInfo-Technical Database (CTSTIPS.NSF)
3. HelpCenter
4. Levels 1 and 2 Support
39
Configuration
Advertisement
Table of Contents
