User Manual of Network Speed Dome
2. Configure the NIC settings, including the IPv4 Address, IPv4 Subnet Mask and
IPv4 Default Gateway.
3. Click
Notes:
If the DHCP server is available, you can check
an IP address and other network settings from that server.
The valid value range of Maximum Transmission Unit(MTU) is 500 ~ 9676. The
default value is 1500.
The Multicast sends a stream to the multicast group address and allows multiple
clients to acquire the stream at the same time by requesting a copy from the
multicast group address.
Before utilizing this function, you have to enable the Multicast function of your
router and configure the gateway of the network speed dome.
If the DNS server settings are required for some applications (e.g., sending
email), you should properly configure the Preferred DNS Server and Alternate
DNS server.
6.3.2 Configuring Port Settings
Purpose:
If there is a router and you want to access the speed dome through Wide Area
Network (WAN), you need to forward the 3 ports for the speed dome.
Steps:
1. Enter the Port Settings interface:
Configuration > Basic Configuration > Network > Port
Or Configuration > Advanced Configuration > Network > Port
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
to save the above settings
Figure 6-8 DNS Server Settings
Figure 6-9 Port Settings
.
to automatically obtain
45