Updated Pcl 5 Docs - QMS 1800409-001A User Manual

Updated PCL 5 DOCs

%%IncludeFeature:scalablefonts(value)
Purpose:
value:
Default:
%%IncludeFeature:install(resource id object id)
Purpose:
resource id:
object id:
A d d i t i o n a l T e c h n i c a l I n f o r m a t i o n
Enables/disables PCL 5 scalable fonts (to print PCL 4
documents that have selected PCL 5 scalable fonts or
to more closely emulate the PCL 4 font environment).
0 (enables scalable fonts) or 1 (disables scalable fonts)
0
Establishes the current resource and the default object
ID value for the current job to which it is attached. If it
is attached to a job that downloads a font without
setting the current object ID using the PCL escape
sequence <ESC>(#X, it has the appearance of
" storing" the
%%IncludeFeature:install DOC command is sent, the
internal default location is used; otherwise, this
parameter, which must be provided, specifies one of
the alternate locations. For most QMS printers,
resource 6 is the internal system disk.
0 to 6 (identifies one of the possible locations for
downloaded objects). Default: internal system disk
0-32767 (assigns an ID to an object, such as a font,
macro, or pattern). Default: 0. The object ID can be
used instead of the usual PCL command to assign an
ID. This ID is overwritten by any ID assigned from the
PCL print job, if present. If neither a DOC command
nor the PCL print job specify an ID, the default ID of
0 is used. Identifiers must be unique. If the ID matches
an ID for an existing object, that object is deleted and
repl ac ed by
%%IncludeFeature:remove command precedes a
%%IncludeFeature:install command, the install
command is ignored (these two commands are
mutually exclusive). All downloaded objects are by
default temporary and will be deleted at the end of a
font on disk.
t he new obje ct .
Appendix D
If no
If a
D - 1 7