Table of Contents
Advertisement
Chapter 4
Plotter
Scaling
Percent
Origin
Reverse
Image
Enhanced
Mode
Expand
Mode
Paper Type
Pens 1-8
4 - 3 2
Choices include 7550A (the factory default), 7475A,
7470A, and ColorPro.
Choices range from 1 to 150 percent of the original
size. The default is 100 percent.
NOTE: To scale plots, select the paper size originally
used for the plot in the Paper Type menu; then enter the
reduction or enlargement needed to fit the plot on the
new page in the Scaling Percent menu. If necessary,
enter new x,y coordinates in the Origin menu to
reposition the plot on the page.
Choices range from 0 to 850 to the right (x direction)
and 0 to 1100 upward (y direction) in .001" increments.
In normal orientation, the 0,0 origin point is the
lower-left corner (when the page is viewed in
landscape orientation) of the imageable area. The
default values are 0000 in the x direction and 0000 in
the y direction.
This option applies only to monochrome printing.
Choices are off (black on a white background) and on
(white on a black background). The default is off.
This option allows you to choose enhanced resolution
for HP-GL output. Choices are off (standard resolution
for fixed- and variable-spaced fonts, 4 x 8 grid) and on
(enhanced resolution for variable-spaced fonts, 26 x 36
grid). The default is off. Use the enhanced mode for
7550A plotter emulation.
Choices are off and on (default scaling points, hard-clip
plotting range, and maximum plotting area are all
expanded). The default is off.
Choices are A, A3, A4, B, and Scale to Paper (the
factory default). Select the media size for which the
plot was originally created.
Pen width choices range from .1 mm to 6 mm, in 0.1
mm increments (you can also enter a value of 0 for a
1-pixel wide line). Color choices are black, violet,
brown, 25% gray, 50% gray, 75% gray, red, orange,
yellow, green, blue, cyan, and magenta.
P r i n t e r C o n f i g u r a t i o n
Advertisement
Table of Contents
