external transceiver). Because of these widths, clearance in front of your hub
may be a factor in the placement of the device or stack that contains
protruding transceiver connectors, for example, a BNC connectors.
Inspect your installation site and identify whether enough room will be
available for the installed transceiver to be connected. Then see the guide that
shipped with your external transceiver for installation instructions. For HP
external transceivers, see the HP Recessed Transceivers Installation Guide
(p/n 5962-0066) for specific instructions.
Your transceiver modules can be one of the following:
3. Verify the hub operates correctly
Before mounting the hub, connect it to a power source and verify that the hub
will operate correctly.
1.
N o t e s
The hub does not have a power switch; it is powered on when the power cord
is plugged in.
HP J2606A Fiber-Optic Transceiver Module
HP J2607A Twisted-Pair Transceiver Module
HP J2608A ThinLAN Transceiver Module
HP J2609A AUI Port Module
Plug the power cord into the hub's power cord receptacle and into an AC
power source.
Connect female end of included power cord
into male receptacle here and male end of
power cord to an alternating current power
source.
Installing the Hub
Installing Your Hub
1-3