Verify The Switch Boots Correctly - HP 2920 Installation And Getting Started Manual

Installing the Switch
Installation Procedures
N o t e
N o t e
2-6

2. Verify the Switch Boots Correctly

If an HP 2920 switch is powered on for the first time without a stacking module
installed, the stacking feature will be disabled and that status will be saved in
the switch's running configuration. For more information, see
Information and Topologies" on page
Before installing the switch in its network location, you should first verify it
is working properly by plugging it into a power source and verifying that it
boots correctly.
1. Connect the power cord supplied with the switch to the power connector
on the back of the switch, and then into a properly grounded electrical
outlet.
Figure 2-2. Connecting the power cord
The HP 2920 switches do not have a power switch. They are powered on when
the power cord is connected to the switch and to a power source. For safety,
the power outlet should be located near the switch installation.
The switch automatically adjusts to any voltage between 100-127 and 200-240
volts and either 50 or 60 Hz. No voltage range settings are required.
If your installation requires a different power cord than the one supplied with
the switch, be sure to use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country. The mark
is your assurance that the power cord can be used safely with the switch.
2-25.
"Stacking