Power Precautions - HP ProCurve 10Base-T 12 Installation Manual

N o t e
If your installation requires a different power cord than the one supplied with
the hub, be sure to use a power cord displaying the mark of the safety agency
that defines the regulations for power cords in your country. The mark is your
assurance that the power cord can be used safely with the hub.
Do not install the hub in an environment where the operating ambient temper-
ature might exceed 45°C (113°F).

Power Precautions

Follow these precautions when unplugging and plugging in power to the hub
as well as adding or removing transceiver modules.
N o t e
The hub does not have a power switch; it is powered on when the power cord
is plugged in. The hub's power supply automatically adjusts to any AC power
source between 100-127 volts and 200-240 volts. There are no voltage range
settings to configure.
When installing the hub, note that the AC outlet must be installed near the
equipment and should be easily accessible.
C-2