Connecting The Hp Procurve 10Base-T Hubs To A Fiber-Optic Backbone - HP ProCurve 10Base-T 12 Installation Manual

Installing the Hub
Installing Your Hub
N o t e
Each ThinLAN cable segment must be terminated using a 50-ohm terminator
at each end. In the illustration above, a 50-ohm terminator is placed at each
end of the cable segment.
Connecting the HP ProCurve 10Base-T Hubs to a Fiber-Optic
Backbone
With a Fiber-Optic transceiver for 10Base-FL networks, you can connect your
hub to a fiber-optic backbone. The following illustration shows a hub with a
Fiber-Optic transceiver connected to a fiber-optic backbone:
Figure 1-8. Fiber-Optic Backbone Connection
For more information about cabling configuration, see the documentation
accompanying the optional recessed transceivers. Also, see the Designing
HP ProCurve Networks (Part Number 5965-6578E) guide for information on
valid network topologies.
1-12
HP J2606A Fiber-Optic
Transceiver Module installed in
the AUI/Xcvr Slot
1 2 3 4 5 6 13 14 15 16 17 18
ProCurve 10Base-T Hub 24M
Xcvr
HP J3303A
7 8 9 10 11 12 19 20 21 22 23 24
Power
Act Col
Reset Clear
Fault Console
Fiber-optic
cable to a
fiber-optic
backbone
1 2X 3X 4X 5X 6X
Port 1 Only
10 Mbps Xcvr Port
MDI-X MDI
(out) (In)
7X 8X 9X 10X 11X 12X
13X 14X 15X 16X 17X 18X
19X 20X 21X 22X 23X 24X