HP ProCurve 10Base-T 12 Installation Manual page 22

Installing the Hub
Installing Your Hub
In the following illustration, the top hub in the stack is connected to two end
nodes and to a second hub. Note the second hub shows Port 1 connecting to
a PC, using a straight through twisted pair cable with the port in the MDI-X
position.
1-10
1 2 3 4 5 6 13 14 15 16 17 18
ProCurve 10Base-T Hub 24M
Xcvr
HP J3303A
7 8 9 10 11 12 19 20 21 22 23 24
Power
Act Col
Reset Clear
Fault Console
Hub attached to Port 1:
switch in MDI position and
straight-through cable used.
Straight-Through
Cable from Hub to PC
Up to 100 meters
1 2 3 4 5 6 13 14 15 16 17 18
ProCurve 10Base-T Hub 24M
Xcvr
HP J3303A
7 8 9 10 11 12 19 20 21 22 23 24
Power
Act Col
Reset Clear
Fault Console
PC attached to Port 1: switch
in MDI-X position and
straight-through cable used.
1 2X 3X 4X 5X 6X
Port 1 Only
10 Mbps Xcvr Port
MDI-X MDI
(out) (In)
7X 8X 9X 10X 11X 12X
1 2X 3X 4X 5X 6X
Port 1 Only
10 Mbps Xcvr Port
MDI
MDI-X
(out) (In)
7X 8X 9X 10X 11X 12X
13X 14X 15X 16X 17X 18X
19X 20X 21X 22X 23X 24X
13X 14X 15X 16X 17X 18X
19X 20X 21X 22X 23X 24X