Mount The Hub; Rack Or Cabinet Mounting - HP ProCurve 10Base-T 12 Installation Manual

4. Mount the hub

Before mounting the hub, unplug it. The HP ProCurve 10Base-T Hubs can
be mounted in three ways:
1.
2.
3.
The hardware for mounting the hub is included in the accessory kit
(5064-2053) packed with the hub. See Appendix C, "Safety and Regulatory
Statements," for general mounting precautions.

Rack or Cabinet Mounting

W a r n i n g
The rack or cabinet should be adequately secured to prevent it from
becoming unstable and/or falling over. Please see Appendix C, "Safety
and Regulatory Statements," for precautions and warnings associated with
rack mounting.
Note that once you have connected cables to the hub, an AUI transceiver
LED or twisted pair Port LED stays on if link beat has been detected at
the port from an incoming device and the port is enabled. A Port LED turns
off if link beat is not detected.
When the self test completes successfully, the LEDs go into their normal
operational states. If a hub hardware fault exists, the hub will not
complete self test. This will be indicated by an abnormal LED pattern,
such as all port LEDs staying lit indefinitely. Note that the normal
operational state could include indefinitely blinking LEDs in the event of
a detected intruder. For managed HP ProCurve 10Base-T Hubs, see your
HP ProCurve 10Base-T Hubs Management and Configuration guide for
more information on Intruder Detection and flashing LEDs associated
with it.
If the self test time range elapses and the Fault LED continues to stay on
instead of turning off, the hub may have an error condition. If repeating
the self test does not correct the problem and the Fault LED still stays
continuously on, contact your HP authorized reseller for replacement
information. After the hub has passed its self test, you are ready to mount
the hub. Unplug the hub and proceed to the next step.
in a rack or cabinet
on the wall
on a table
Installing the Hub
Installing Your Hub
1-5