IBM High Performance Storage System HPSS Installation Manual page 148

5. Select the "Configure Authorization Service" checkbox. Set the "Authorization Service" to
"Unix and config files".
6. Review and modify (if necessary) the following authorization fields:
Local Site Name. The value is usually set to the full host name of the local host.
•
This can be determined by using the 'hostname' and 'domainname' commands.
Local Realm Name. The value is usually set to the "Local Site Name" all
•
capitalized.
Local Realm ID. The field is set to a unique ID number for each site. Ask your
•
support representative for an appropriate value.
7. By default, the system's configuration files (/etc/passwd, /etc/group, and /etc/shadow) are
used to administer the authentication and authorization services. As an option, the HPSS
configuration files can be used instead. These files will be created by mkhpss as part of this
configuration. Other HPSS utilities are available to administer these HPSS configuration
files. Refer to Section 2.2.2: Security Mechanisms in the HPSS Management Guide for more
information. To use the HPSS configuration files, select the "Enable local Unix Passwd
Files" checkbox. The default names for the files should be used as displayed.
HPSS Installation Guide
Release 6.2 (Revision 2.0)
July 2008
148