Operating Your Keypad - GE KTD-405 User Manual

30 KTD-405 Keypad
User Manual

Operating your keypad

Remember that the addressing between domes and multiplexers is offset. When setting up and controlling your
cameras in zone mode, refer to Appendix A (Zone Receiver Site Addressing).
Table 3 shows the keypad's normal and shifted (secondary) key functions.
Table 3. Normal and shifted key functions
Key Normal function
mon With number keys, selects active monitor from matrix switcher or multiplexer
view Works in two ways, depending on the type of multiplexer or DVMRe you are addressing:
for duplex DVMRes and most multiplexers, pressing view steps selected monitor through
programmed multiscreen views (if view is pressed and held for 5 sec, the keypad will
broadcast a command to all CyberDomes to display their site address and zone mode;
Calibur devices will display their address; status disappears when the key is released) for
triplex DVMRes and some brands of multiplexers, pressing view with number keys
selects multiscreen views (view, 2 calls up 2 x 2 view, and view, 4 calls up 4 x 4 view).
zone With number keys, selects a zone.
aux 1 Default assignment sends "open" command to selected camera address.
aux 2 Close.
aux 3 Stop.
aux 4 Last for KTD-405; talk for KTD-405A.
seq Activates a sequence tour on the active monitor (Calibur multiplexers only).
alarm Toggles active monitor between the alarm on and alarm off modes; calls up help menus
when remotely programming matrix switcher and CyberDome.
tour With number keys 1 – 4 (1 only, for CyberScout), places PTZ receiver in tour mode; or, if
pressed and held for 3 sec, keypad beeps and sends an autopan command to PTZ
receiver.
store With number keys, sets presets and autopan limits for selected camera; accesses
sequence programming for Calibur multiplexers.
find With number keys, selects PTZ position saved by the previous store command for
selected camera site.
+zoom - Controls the zoom function on selected receiver site's motorized zoom lens.
+focus - Controls the focus function on selected receiver site's motorized zoom lens; disables the
autofocus feature on CyberDome.
+iris - Controls the iris function on selected receiver site's motorized zoom lens.
esc With number keys, clears alarms and clears number entry.
1st Selects earliest of pending annunciations.
autofocus Places selected CyberDome camera in autofocus mode.
0 – 9 Selects camera (selects any numeric entry following other keys).
8 Places selected DSR, DVMRe, or VCR in fast forward mode.
Shifted function
help
group
unlock
lock
flip
stabilize
function
group
step
volume up/down
backlight bright/dim
macro
autopan
site up