Table of Contents
Advertisement
Step 3. (a) If mounting into drywall, use the plastic
anchors. Using a 3/16" drill bit, drill holes and insert
anchors for a snug fit. Align mounting plate holes to
anchor holes, insert screws and screw in until plate
has secure fit. Do not over-tighten screws.
Step 3. (b) If mounting into a stud or wood surface, use
a 1/8" drill bit, drill holes. Align mounting plate holes to
drilled holes, insert screws and screw in until plate has
secure fit. Do not over-tighten screws.
Removing the Top cover from
the Mounting Plate
To remove the top cover, locate the snap
latch at the bottom of the plate. Using a
paperclip or small blade-type screwdriver,
gently push in on the latch. The top cover will
separate from the mounting plate and can
be lifted off
Attaching the Top Cover to the Mounting
Plate
To secure top cover onto mounting plate, position
top cover over mounting plate and gently apply
equal pressure to top cover. It will snap securely in
place onto the mounting plate. Check all sides to
ensure secure fit.
Operating the Wireless Keypad
Panic Button
Home Button
Arming the Alarm in Away mode
Enter a 4-digit user code (See Programming Security
Codes into the Wireless Keypad) and press the Away
Disarm Button
Away Button
11
1
2
3
4
Advertisement
Table of Contents
