GE KTD-405 User Manual page 25

6. The following access menus (Figure 19) are
used to restrict the keypad from addressing
specified sites in the system.
The access menus enable you to allow
access for each camera, monitor, DSR/
VCR, and multiplexer. To move from
one type of access menu to another,
press or .
Note: If you do not want to interrupt viewing at
another keypad, program the keypad to
address only the monitors within its view.
7. Pressing + displays the following menu
(Figure 20). The VCR output can be
assigned an input number on the matrix
switcher. When a VCR is called, the matrix
switcher switches to the assigned input.
Enter a number from 1 through 511, or enter
0 for NONE.
8. These menus (Figure 21) are used to
configure multiplexers.
9. Use or or the joystick to scroll through
multiplexer manufacturers.
10. If the DVMRe/multiplexer's outputs are
connected to an input on a matrix switcher,
enter the input number (1 to 511, or 0 for
none).
11. Enter the number of outputs (1 to 5)
connected to the matrix switcher. This
returns you to the MPLX xx ACCESS menu.
Note: Outputs must be connected in sequential
order to inputs if more than one output
from a single DVMRe/mux is used.
Figure 19. Access menus
CAMERA 000 ACCESS?
(+)=YES (-)=NO
MONITOR 01 ACCESS?
(+)=YES (-)=NO
DSR/VCR 01 ACCESS?
(+)=YES (-)=NO
Figure 20. VCR access display
VCR 01 MATRIX INPUT:
000 (0=NONE)
Figure 21. Multiplexer access display
MPLX 01 ACCESS?
(+)=YES (-)=NO
MPLX01 BRAND
( , )=SELECT
MPLX 01 MATRIX INPUT?
000 (0=NONE)
SELECT MAX OUTPUTS: 02
( , )=SELECT
Chapter 3
Programming
YES
NEXT
YES
NEXT
YES
NEXT
NEXT
YES
NEXT
DVMRE DUP
NEXT
NEXT
NEXT
21