Setting Autopan Limits; Selecting A Monitor - GE KTD-405 User Manual

Setting autopan limits

You can set the left and right autopan limits separately.
Left autopan limit
To set the limit for the left turn-around point of the camera's back and forth motion, as wells as the tilt and
zoom positions for the autopan, do the following:
1. Position the camera at the desired left limit.
2. Tilt and zoom the camera into the desired position.
3. Press store.
Note: Do not attempt to enter a preset number. The preset number 62 is reserved for the left autopan limit and is
automatically entered when you perform step 5.
4. Press .
5. Press store again. The Store Preset Number displays on the keypad.
Right autopan limit
To set the limit for the right turn-around point of the camera's back and forth motion, do the following:
1. Position the camera at the desired right limit and press store.
Note: Do not attempt to enter a preset number. The preset number 63 is reserved for the right autopan limit and is
automatically entered when you perform step 3.
2. Press .
3. Press store again. The Store Preset Number displays on the keypad.

Selecting a monitor

The monitor selection is internal to the keypad; no command is sent to the switcher. There are two monitor-
selection methods:
1. Press the mon key.
2. Enter the monitor number including any preceding zeros, or enter the monitor number directly, then
press .
Chapter 4 33
Operation