REPLACING THE FUSE
If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the
fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
PROCEDURE:
1.
remove the fuse holder on the rear panel with a fitting screwdriver from the housing
2.
remove the old fuse from the fuse holder
3.
install the new fuse in the fuse holder
4.
replace the fuse holder in the housing and fix it
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a
special power supply cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply
Power consumption
DMX control channels
DMX 512 connection
Length
Width
Height
Net weight
Maximum ambient temperature
Maximum housing temperature
Min distance from flammable surfaces
Min distance from lighted object
Fuse
Please note: Every information is subject to change without prior notice.
230V / 50Hz
(117V / 60Hz USA)
800W
10
3-pin XLR
470 mm
410 mm
480 mm
27 kg
45 °C
90 °C
1,5 m
1,5 m
F5A, 250V
29