Operation; Dmx Addressing - PROEL TARKUS 575 SPOT User Manual

OPERATION

After you connected the effect to the mains, the moving head PLML575SCN starts
running. During the Reset, the motors are trimmed and the device is ready for use
afterwards.
You can control the projectors individually via your DMX-controller. Every DMX-channel
has a different occupation with different features. In order to call up the different features,
you first have to open the shutter (control channel 4, DMX-value 241-255).

DMX ADDRESSING

Each projector occupies 10 channels. To ensure that the control signals are properly
directed to each projector, the projector requires addressing.
To assign the channel, rotate the multifunctional knob until the display shows 575SCN
Addr. 001 . Press the knob and set the starting channel by rotating the same knob.
Press the multifunctional knob to confirm the value of DMX starting address.
NOTE:
After switching on, the MOVING HEAD PLML575SCN will automatically detect whether DMX
512 data is received or not. If the data is received, the display will show the actually set
address and the "d" is lit. If there is no data received at the DMX-input, the "d" letter is off. This
situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the
input of the moving head
- the controller is switched off or defective
- the cable or connector is defective or the signal wires are swap in the input connector
To invert Pan movement, rotate the multifunctional knob until the display shows Reverse
Pan . Press the knob and rotate it to set the normal mode (N) or reverse mode (Y).
Finally press the same knob to confirm the setting.
To invert Pan movement, rotate the multifunctional knob until the display shows Reverse
Pan . Press the knob and rotate it to set the normal mode (N) or reverse mode (Y).
Finally press the same knob to confirm the setting.
MENU button two times until it is shown PAN, than press ENTER.
To invert Tilt movement, press the MENU button three times and until it is shown TILT,
than press ENTER.
Please make sure that you don't have any overlapping channels in order to control each
moving head correctly and independently from any other fixture on the DMX data link. If
two, three or more moving head is addressed similarly, they will work similarly.
After having addressed all moving head, you may now start operating these via your
lighting controller.
27