The Helmet; Conformance To Standards; Ece Approval An Dot-Label; Anatomy The Helmet - SCHUBERTH S2 Owner's Manual

D. THE HELMET

1. CONFORMANCE TO STANDARDS

The helmet conforms to the DOT 218 Standard and the ECE R 22.05
standard. These test standards guarantee conformity to defined
safety standards in respect of impact absorption, penetration
resistance, lateral rigidity, retention system and field of vision.
The approval guarantees that you have approval for the USA
and all the countries of the European Union as well as countries
which recognize the ECE R 22.05 or DOT 218 standard. It is only
legal to use it in countries where these standards are valid.
2. ECE APPROVAL and DOT-LABEL (fixed to the comfort
padding of the retention system)
ECE test standard
Certification number
051234/P-1234
DOT-Label (fixed to the rear side of the helmet)
58
Certifying authority
Serial number
3. ANATOMY OF THE HELMET
Integrated antennas
Face shield
Reflex eyes
Sun visor
Inner lining
Face shield ventilation /
Chin ventilation
Chinstrap
(with ratchet fastener)

4. OUTER SHELL

The outer shell of the S2 combines an aerodynamically optimal
shape that is suitable for racing with thorough protection.
It consists of glassfibre reinforced vinylester (GRP) with
polyethylene fibre reinforced layers. This structure gives the
helmet the high level of strength and rigidity needed for your
protection*.
* The helmet is designed to provide the safety performance required by the United
States DOT 218 Standard in combination with the European ECE R 22.05 Standard
Warning:
The safety helmet is designed to absorb the effect of only one
impact. The helmet must be replaced after a fall, accident or
any other impact.
Note:
For cleaning instructions see section H.1. (maintenance and
care –outer shell) of this manual.
Head inlet vent
Inner shell
Head outlet vent
®
Pinlock visor
Face shield mechanism
Outer shell
Retention system
(with anti-roll-off system)
Operating slide for
sun visor
59