SCHUBERTH S2 Owner's Manual page 16

D. THE HELMET
Fitting the high-comfort cheek pads
1. Button the chinstrap pad on to the
chinstrap and thread the chinstrap
through the loop on the chinstrap
pad.
2. Thread the neckband through the
neckband channel.
3. Push the chinstrap and chinstrap
pad through the opening in the
high-comfort cheek pad.
4. Now pull the loop of the neckband
over the chinstrap and pull the
neckband tight from the back.
78
5. Push the plastic tongue with round
holes on the head pad over the pin
sewn in to the back of the cheek
pad and fix it in place using the
red plug-in strip.
6. Fix the remaining two pins on the
cheek pad into the red plug-in
strips.
7. Replace the acoustic collar in the
guide strip between the bottom
edge of the helmet and the high-
comfort cheek pads. Start inserting
it at the back and slowly feed the
acoustic collar along the guide
strip.
8. Repeat steps 2 - 6 for the second
cheek pad.
Note:
Ensure that the neckbands are not twisted.
79