Sun Visor - SCHUBERTH S2 Owner's Manual

D. THE HELMET
Note:
Never press the locking pins out with your fingers as they may
break.
Caution:
As a result of the double shield lens structure, there is a
possibility of greater light reflection in the face schield,
especially when riding at night. As a rule, such light reflection
is regarded as uncritical due to the absence of misting with
this type of visor. However, if this light reflection should cause
you difficulties - because of particular sensitivity to it, for
example - you should refrain from using the Pinlock
Caution:
If moisture is present in or has penetrated the airtight area
between the two plates, you should remove the Pinlock
visor immediately in order to prevent any interference with
visibility. Do not re-fit it until both plstes are completely
dry (we recommend air-drying). If you should subsequently
detect any further penetration of moisture, the Pinlock
should not be used on any account and must be replaced.
Safety note
Check before each journey that the face shield and suns visor
mechanism are functioning correctly and that the face shield and
sun visor will provide good visibility. Any dirt should be removed
before setting off. Check the face shield and sun visor for physical
damage and cracks. Severely scratched or matt face shields will
seriously impair visibility and should be replaced before setting
off on a journey.
Caution:
Petrol, solvent and fuel vapours can cause cracking of the
face shield . Make sure that the face shield is never exposed
to such vapours! Never place the helmet on the tank of your
bike.
72

11. SUN VISOR

Sun visor
The sun visor is tinted grey and has a 3D shape. Thanks to the
sun visor's 1.5mm thickness, it provides protection against small
stone chips or insects when driving with the visor up. It is also
scratch-resistant and offers effective UV protection* with
its special polycarbonate structure.
* Tested in accordance with the Australian sunglasses standard AS/NZS 1067:2003 lens
category 3.
®
visor.
Operation
®
The sun visor is operated by means of the slide positioned on the
left in the chin area, which is easy to use even when wearing
gloves.
® visor
Moving the slide towards the back
lowers the sun visor, moving it
forwards retracts the sun visor inside
the inner helmet shell and locks it in
position.
The sun visor can be operated irrespective
of the position of the face shield.
Note:
Only use the slide to operate the sun visor.
Caution:
Never ride in the dark or in conditions of poor visibility with
the sun visor down. Always raise the sun visor before entering
a tunnel.
73