SCHUBERTH S2 Owner's Manual page 9

D. THE HELMET
Adjusting the chinstrap
The length of the chinstrap is adjusted by increasing or reducing
the length of strap pulled through the metal buckle. Adjust the
length of the chinstrap so that it fi ts fi rmly but comfortably
under your chin and fi x the end of the strap using the retaining
loop with comfort pad.
Caution:
When adjusting the strap, make sure that the helmet cannot
be pulled off in a forward direction with the chinstrap closed
Caution:
Check the adjustment of the chinstrap length at regular
intervals (see section F. 2.).
Opening and closing
To close the chinstrap fastener, slide the ratchet tongue step by
step into the locking buckle. If you fi nd that the chinstrap fi ts
too loosely around your chin, slide the ratchet tongue one step
further into the locking buckle.
When adjusting the chinstrap, make sure that it rests fi rmly but
not uncomfortably around your chin. To open the chinstrap, pull
the red ribbon on the ratchet fastener upwards to release the
locking buckle. Then pull the ratchet tongue out of the locking
buckle.
64
Warning:
The chin strap must be positioned under the chin!
Warning:
Never ride without making sure that the chinstrap is correctly
fastened and adjusted and properly positioned. If the
chinstrap is not correctly adjusted or fastened, the helmet
could be displaced in the event of an accident.
Warning:
Do not twist the strap! The dented part of the tongue must be
facing the inside of the helmet!
Warning:
Closing the comfort pad of the chinstrap alone will not
provide adequate protection. The chinstrap must always be
fully fastened.
Warning:
Never open the chinstrap while riding.
Warning:
Pull the red strap only to remove your helmet!
Never pull the red strap while riding!
65