SCHUBERTH S2 Owner's Manual page 12

D. THE HELMET
3. The Pinlock ® visor should now be
positioned in the face shield with
its lower edge parallel to the lower
edge of the face shield. If you
need to change the positioning of
the Pinlock ® visor, use the balls of
your thumbs to gently bend the
face shield apart until the inner
visor can be adjusted as required.
4. Check all round the visor to make
sure that the silicone seal fits
tightly and evenly against the
face shield. Only if this is the case
will the anti-misting properties
function properly.
5. If you have not done so already,
remove the protective film from
the Pinlock ® visor
If the Pinlock ® visor is not air-tight and the face shield mists
up, either the visor is not correctly in place or the pressure on
the seal is inadequate. You can regulate the pressure on the
seal by adjusting the eccentric locking pins. To do so, remove
®
the Pinlock visor, then use a flat object with no sharp-edges
to push the locking pins out of the face shield carefully from
the inside; then rotate them by 180° and reinsert them. Fit the
®
Pinlock visor and check the seal.
Removal
1. Before starting to remove the
Pinlock ® visor, first lay the face
shield on a soft, clean cloth so
that its top edge is facing you.
70
2. To reduce the pretensioning of the
Pinlock ® visor slightly if necessary,
use the balls of your thumbs to
carefully bend the face shield
sufficiently apart while applying
pressure with your thumbs to
release the Pinlock ® visor and
move it approx. 2-3 mm forward.
3. Now grip the back of the Pinlock
visor with your index and middle
fingers and lift it off the face
shield. In this position you can
easily remove the Pinlock ® visor
from the locking pin with your
thumb.
4. You can now remove the Pinlock
visor from the face shield.
Note:
• to avoid scratching the face schield, never remove or fit
the Pinlock ® visor unless the visor unit is clean and dry.
• When fitting the Pinlock
nor moisture are able to get between the two plates.
• When removing or fitting the Pinlock
best to lay the face schield unit on a clean, dry cloth.
• Check regularly to ensure that the fit of the silicone seal
between the face shield and the Pinlock
and even.
Note:
In view of the strong air pressure acting on the silicone seal
when travelling with an open face schield, we recommend
riding with a closed face schield at all times to prevent any
dirt or moisture from getting inside the helmet.
®
®
® shield, check that neither dust
® visor, it is always
® visor is tight
71