Maintenance And Care; Outer Shell; Face Shield And Sun Visor - SCHUBERTH S2 Owner's Manual

H. MAINTENANCE AND CARE

1. OUTER SHELL

To clean the helmet shell, you can use water, soapy water or
one of the commonly available motorcycle shampoos, cleaners,
polishes and plastic cleaners, or cleaning fluid. The use of water
and soapy water is usually sufficient. Make sure when using the
other cleaning materials that these do not come into contact
with the visor, since these can cause damage to the visor and
coating.
Warning:
Never use motor fuel, thinners, glass cleaner or other solvents
to clean the helmet! Your helmet can be seriously damaged
by these substances without visible damage.
Warning:
A helmet damaged or weakened by a cleaning agent may not
provide head protection in an accident resulting in serious
personal injury or death!
Warning:
Never use hot or salt water to clean the helmet. Your helmet
can be seriously damaged by this treatment without damage
being visible to you.

2. FACE SHIELD AND SUN VISOR

PINLOCK® VISOR
Outer surface of the face shield
Use a soft cloth and a mild soap solution (< 20 °C) to remove dirt
from the outside of the face shield. To dry the face shield, use a
lint-free cloth and apply gentle pressure.
96
Inside surface of the face shield
The inside surface of the face shield must only be cleaned with
a soft cloth, which may be slightly dampened if required (we
recommend a mocrofibre cloth). Do not use any cleaning agents.
SUN VISOR
The sun visor should only be cleaned with a soft and, if
necessary, slightly damp cloth (we recommend a microfibre
cloth). Do not use any cleaning agents.
Note:
Only use tepid water (< 20 °C) for cleaning. Never on any account
clean the face shield or sun visor with petrol, solvent, a window
or glass cleaner or other cleaning agents containing alcohol.
Note:
The face shield should not be soaked in water even if it is very
dirty on the outside, as this will severely reduce the surface
hardness and thus the durability of the anti-fog/anti-scratch
coating.
Note:
The face shield should not be completely closed when not in
use (particularly during periods of storage), as the moisture
contained on the inside cannot escape if closed and will
largely be absorbed by the anti-fog/anti-scratch coating. This
can lead to a reduction in the lifespan of the coating. Ideally,
position the face shield in the third locking setting above the
urban position.
Note:
Never attach labels, adhesive tape or stickers to the face
shield or sun visor.
97