Receiver Settings; Preparing The Transmitter, Using A Futaba T8J As Example - ROBBE BLUE ARROW Operating Instructions Manual

A
C
D
W
Receiver settings (large case), S-FHSS module settings (small circuit board on the receiver):
No reception/
Binding required
Initialising transmitter signal
Receiving transmitter signal
Preparing the transmitter, using the Futaba T8J as an example:
- Set S-FHSS modulation
- The radio control transmitter must be set to swashplate mode H-1 (see T8J instructions, 8.1 Parameters, page 38)
- Reverse the roll (CH1), pitch-axis (CH2), throttle (CH3), tail rotor (CH4) and collective pitch (CH6) channels (see T8J instructions, 7.10
Servo reverse (SERVO REV), page 20)
Binding the transmitter to the model:
- Switch the transmitter on
- Hold button D (binding button) pressed in while you connect the flight battery
- If initialisation (binding) is successful, the receiver's Status LED flashes slowly, and the S-FHSS module LED glows constantly
- Binding is retained when the system is switched off. The procedure only needs to be repeated if you replace the receiver or transmitter
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537
A = Main motor connectors
B = Tail rotor motor connectors
C = S-FHSS module
D = Binding button
Disconnect the main and tail rotor
motor connectors before binding the
transmitter and before making any
other adjustments on the model.
Receiver status LED
Very fast flashing
Fast flashing
Slow flashing
Battery connector:
S-FHSS module status LED
Fast flashing
Continuous light
Continuous light
9