Receiver Settings; Installing The Flight Battery - ROBBE BLUE ARROW CP120 S-FHSS RTB Operating Instructions Manual

D
C
W
A
Receiver settings (large case), S-FHSS module settings (small circuit board on the receiver):
No reception/
Binding required
Initialising transmitter signal
Receiving transmitter signal
Preparing the transmitter, using the Futaba T8J as an example:
- Set S-FHSS modulation
- The transmitter must be set to swashplate mode H-1 (see T8J instructions, 8.1 Parameter, page 38)
- Reverse the roll (CH1), pitch-axis (CH2), throttle (CH3), tail rotor (CH4) and collective pitch (CH6) channels (see T8J instructions, 7.10
Servo reverse (SERVO REV), page 20)
10
Operating Instructions - BLUE ARROW CP120 S-FHSS RTB 2.4 GHz No. S2540
A = BL motor socket
E
B = S-FHSS module servo
G
C = Binding button
D = Pitch-axis servo
Disconnect the brushless motor con-
F nector before binding the transmitter
and before making any other adjust-
ments on the model.
Receiver status LED
Very fast flashing
Fast flashing
Continuous light
E = Roll servo

Installing the flight battery:

F = Collective pitch
G = Tail rotor servo
S-FHSS module status LED
Fast flashing
Continuous light
Continuous light