System Setup Menú; Lnb Setup - Televes RSD - 7296 User Manual

User Manual User Manual
9.- System Setup Menú

9.1.- LNB Setup

This Menú lets you enter the configuration parameters of the system.
Access the Menú by pressing with the OK button over the "System Setup"
option of the main Menú. You can assign satellites, LNBs and switches to
16 antennas in this Menú.
You can save up to 16 types of configuration for the antenna.
Select the "LNB Setup" option in the -System Setup- Menú by pressing
the OK button over it. Use the numberic buttons or the
tons to select the total nº of LNBs that are available in your installation
and press the OK button again.
Assign the appropriate values to each of the following options, which
correspond to each LNB configuration:
- Type of LNB: Indicate if the LNB located on the antenna is universal or
not. If it is, the "High Frequency" and "Low Frequency" option remain
inactive.
- Lo. Freq. / Hi. Freq.: Enter the appropriate frequency for each of the
bands (high and low) if you are not using a universal LNB.
- DiSEqC: If in the -Number of LNB's- option you have selected "1", the
option appears as DiSEqC 1.2 by default, corresonding to a motorised
antenna and controlled by a compatible DiSEqC 1.2 motor. The
"< DiSEqC 1.2 disabled >" option will become active immediately.
If in the -Number of LNB's- option you have selected "2", you will dis-
pose of the "DiSEqC 1.0" or "Tone Burst" options, corresponding to a
fixed antenna and a multisatellite system; or else two fixed antennas
orientated towards different satellites.
Finally if in the -Number of LNB's- option you have selected the LNB nº
> "3", you will dispose of the "DiSEqC 1.0" or "DiSEqC 1.1" options,
corresponding to various antennas.
- Switch: With the -DiSEqC- option in "Tone Burst" mode you can select
one of the following options: "No", "A" or "B".
With the -DiSEqC- option in "DiSEqC 1.0" mode you can select one of
the following options "No", "A", "B", "C" or "D".
With the -DiSEqC- option in "DiSEqC 1.1" mode you can select one of
the following options "No", "1", "2", ... "16".
Regardless of the type of switch, each input corresponds to a specific
LNB.
- Power: Select "On" or "Off" for the LNB powering.
and but-
59
"RSD - 7296" "RSD - 7296"