Factory Values (Restore Default Values); Audio Selection - Televes RSD - 7296 User Manual

User Manual User Manual

8.5.- Factory values (Restore default values)

This option will change all of the parameters that you have entered back to
those established by default at the factory.
The receiver will carry out the following changes when you press OK
over the "Factory Default":
- All of the specifications entered for the transponders, will return
back to the default values set at the factory.
- All of the channels on the list will be erased and replaced by those
pre-set at the factory.
- All of the options installed by the user will be replaced by those
pre-set at the factory.
When you select this option, a warning message will appear onscreen
requesting confirmation.

8.6.- Audio selection

In this Menú, you can select the type of audio used by the loudspeakers.
Select one of the three options; "Stereo", "Left Audio" or "Right Audio"
by using the or
If you want the audio that you have chosen to be permanent, press OK.
buttons.
57
"RSD - 7296" "RSD - 7296"