Access Code Into Memory - Regency 400 Series User Manual

User's Guide

Access Code into Memory

In most cases, this feature is not
used. It is usually only required
when the telephone is installed
outside of a residential application
where you may have to dial a
number(s), such as "9", to get an
outside line. Whatever number(s) is programmed as an Access
Code will automatically be dialed, followed by a 3 second
pause, prior to any number dialed from Speed Dial, or from the
Call Back Feature.
To set up the access code:
1 Press the DIRECTORY / STORE key until the display screen reads
ENTER ACCESS CODE.
2 Enter the desired number, such as 9.
Note: There is no need to enter PAUSE. The Dial Call Back
operation automatically inserts a 3 second pause after the
access code number is dialed.
To delete the access code:
1 Press the DIRECTORY / STORE key until the display screen reads
ENTER ACCESS CODE.
2 Press the DELETE key.
3 Press the DIRECTORY / STORE key again and the screen will go
back to its normal position after a 15 second delay.
15
Programming The Telephone
Regency™ Series 400 Single Line Caller ID Telephone