Table of Contents
Advertisement
User's Guide
Speed Dial continued
Manual entry for memory storing
1
Confirm the display is in the idle mode as
shown in Figure 1.
2
Press the DIRECTORY / STORE key until the
LCD display is similar to Figure 2.
3
Press the UP / DOWN key to change the
memory location to the desired memory
location. (MEM 1, MEM2, ... MEM10) (See
Figure 2 then 3.)
4
Enter the name by pressing the alphabetic
characters repeatedly on the keypad.
(see keypad guide on next page)
5
Use delete key to delete an incorrect
entry.
6
When the name is complete, press the
DIRECTORY STORE key once to store the
information.
7
The LCD will request NUMBER (Figure 4.)
8
Enter the number using the dialing
keypad. Press the DIRECTORY STORE key.
9
Press the DIRECTORY / STORE key twice to
bypass the store AREA CODE and ACCESS
CODE. These two areas are not part of the speed dial programming and any
changes could affect the proper operation of other features. See pages
13-15 for further information about AREA CODE AND ACCESS CODE.
To program additional numbers, repeat steps 2 thru 9.
Manual entry from keypad (guide).
Regency™ Series 400 Single Line Caller ID Telephone
Programming The Telephone
Figure 1
Figure 2
Figure 3
Figure 4
20
Advertisement
Table of Contents
