B L U E
P O W E R
Configure more than one switch to one node
2 sec
1. Do the procedure as in ´Configure
one switch to one node´.
2. Push the + and – for two seconds.
The display shows C1.
Change priority
2 sec
C1
1. Push the + and – for two seconds.
The display shows C1.
22
C1
3. Push the first configured switch
button shortly.
2. Push the + 2 times shortly.
The display shows P0.
3. Push the – to set the priority.
The display shows P1, P2 or P3.
P1 is high priority.
C4
1
P0
x 2
P1
Installation & operation manual
#
4. Push the desired switch shortly. The
switch is configured automatically to
the same mode as the first switch.
The display turns off.
#
4. Push the switch button that
corresponds to the node.
The display turns off.
Caution!
Do not set all appliances to
the same priority.