Table of Contents
Advertisement
Installation & operation manual
Configure one switch to one node
2 sec
C1
1. Push the + and – for two seconds.
The display shows C1.
Configure one switch to more than one node
Use the above procedure. Repeat the
procedure for each node that you want
to connect to the switch.
C2
2. Connect the appliance to the node.
The display shows C2. The buzzer
gives a signal.
Toggle
Direct
C3
5 sec
3. Push the desired push button.
•
Push shortly to select toggle
mode. The display turns off and
the buzzer stops.
•
Push for 5 seconds to select
direct mode. The display shows
C3 and the buzzer stops.
B L U E
P O W E R
21
Advertisement
Table of Contents
