Table of Contents
Advertisement
3.3.2. Smart BatteryProtect remote on/off switch
The below example shows a Smart BatteryProtect in a simple system with a remote on/off switch wired to the remote terminals.
This switch can be used, for example, to turn the system remotely on and off. The power consumption of the Smart BatteryProtect
is negligible at less than 1mA when switched off (check the
3.3.3. Smart BatteryProtect in a lithium battery system with external BMS
The image below shows a Smart BatteryProtect in a lithium battery system with external BMS. The external BMS
Smart BMS
in this example) has an ATD (allowed to discharge) and ATC (allowed to charge) output. Designed as a dry contact,
ATD and ATC function as a switch that directly controls the SBP via its remote terminal.
For this, the Smart BatteryProtect must be programmed to Li-ion mode.
The dry contact is wired between the L and H connectors of the remote terminal.
If, for example, ATD opens in the event of a lithium battery cell undervoltage, the SBP will immediately disconnect the load without
delay.
The SBP will remain disengaged for 30 seconds, even if ATD closes within this period. After this 30 seconds, it responds
immediately and connects the load to the battery.
Please note that the under voltage thresholds and alarm output of the SBP are inactive in this mode.
If you have a lithium battery with internal BMS (so-called drop-ins) that does not have an output for controlling
loads or chargers, the SBP must be programmed in mode A or B. Mode C is not applicable in this case.
Smart BatteryProtect in Li-ion mode controlled by ATD from a Lynx Smart BMS
Page 6
Smart BatteryProtect 12/24V
Specifications chapter
System on/off switch
Smart BatteryProtect with remote on/off switch
Lynx Smart BMS
ATD (allowed to discharge)
BMS cables
[14]).
DC loads
SBP-65
DC loads
Installation and wiring examples
(Victron Lynx
Advertisement
Table of Contents
