Table of Contents
Advertisement
B L U E
P O W E R
Connect to the battery
1. If necessary, adjust the length of the
bus wires at the main fuse box.
2. Remove the cover of the main fuse
box.
3. Loosen the screw to remove the wire
on the fuse.
Note: Do the procedure for one wire
at a time.
12
15 mm
5/8"
4. Cut the wire.
5. Remove 15 mm (5/8") of the
insulation at the end of the wire. Use
the cable cutter to cut the insulation.
6. Place the wire back on its place.
7. Tighten the screw to secure the wire.
Warning!
Follow the instructions
properly to reduce the risk of
future shortcut with possible
fire.
Installation & operation manual
20 mm
6/8"
8. Clamp the bundles of + (red) and –
(black) battery wires with at least
20 mm (6/8") distance in between.
9. Connect the red cable to the +
terminal on the battery.
10. Connect the black cable to the -
terminal on the battery.
Warning!
Make sure there is no risk of
physical damage for the
cables. In case there is a risk,
protect the cables with
grummets or equivalent.
Advertisement
Table of Contents
