Step 6: Install Duct Bracket - GE Monogram ZV750 Installation Instructions Manual

Step
6
• Install the 2 small screws into the sides of
the duct bracket. Remove the screws. This
will insure ease of final installation.
• Temporarily install a piece of 6" duct cut to
length between the hood outlet and the
Install Duct
ductwork at the ceiling.
Bracket
• Position the upper duct bracket behind the
(for vertical exhaust)
duct and against the wall and ceiling.
• Use a level to check that duct is vertical and
GO TO STEP 6A
duct bracket is centered.
IF YOU ARE
• Mark the 4 screw locations of the bracket.
VENTING TO
• Remove the bracket and temporary duct
THE REAR
section.
• Drill 1/8" pilot holes in marked bracket
location.
• If pilot holes do not enter studs, enlarge the
holes 3/8" and install wall fastener anchors.
Drive screws into the
fasteners to allow anchors
to expand against the wall
material. Remove the screws.
• Secure the bracket to the
ceiling and wall with wood
screws and/or wall fastener
screws.
Step 6
The upper duct bracket should be installed against
the ceiling. This bracket will hold the decorative
A
duct cover in place at the top.
• Install the 2 small screws into the sides of the duct
Install Duct bracket. Remove the screws. This will insure ease
of final installation.
Bracket
• Position the bracket against the wall and ceiling.
(for horizontal exhaust)
Center the bracket using marked centerline of
the hood.
SKIP THIS
• Use a pencil to mark the bracket location along
STEP IF
GO TO STEP 6A
its outside edges.
YOU ARE
IF YOU ARE
• Temporarily place the decorative duct cover on
VENTING
VENTING TO
top of the hood and extend the inner portion to
VERTICALLY
THE REAR
meet the ceiling.
(Straight-Up)
• The duct cover should be level and align with
marks for bracket.
• Remove the duct cover.
• Place bracket against marked location and mark
the 4 screw locations.
• Drill 1/8" pilot holes in marked location.
• If pilot holes do not enter studs, enlarge the
holes 3/8" and install wall fastener anchors.
Drive screws into the fasteners to allow anchors
to expand against the wall material. Remove
the screws.
• Secure the bracket to the ceiling and wall with
wood screws and/or wall fastener screws.
Installation
36" Vent Hood
Duct
Work
9