Step 6: Install Duct Bracket - GE ZV750 Installation Instructions Manual

Step 6
• Install the 2 small screws into the sides of the
duct bracket. Remove the screws. This will
insure ease of final installation.
• Temporarily install a piece of 6" duct cut to
Install Duct
length between the hood outlet and the
ductwork at the ceiling.
Bracket
• Position the upper duct bracket behind the
(for vertical exhaust)
duct and against the wall and ceiling.
• Use a level to check that duct is vertical and
GO TO STEP 6A
duct bracket is centered.
IF YOU ARE
• Mark the 4 screw locations of the bracket.
VENTING TO
• Remove the bracket and temporary duct
THE REAR
section.
• Drill 1/8" pilot holes in marked bracket
location.
• If pilot holes do not enter studs, enlarge the
holes 3/8" and install wall fastener anchors.
Drive screws into the
fasteners to allow anchors
to expand against the wall
material. Remove the
screws.
• Secure the bracket to the
ceiling and wall with wood
screws and/or wall
fastener screws.
Step 6
The upper duct bracket should be installed
against the ceiling. This bracket will hold the
A
decorative duct cover in place at the top.
• Install the 2 small screws into the sides of the
Install Duct
duct bracket. Remove the screws. This will
insure ease of final installation.
Bracket
• Position the bracket against the wall and
(for horizontal exhaust)
ceiling. Center the bracket using marked
centerline of the hood.
SKIP THIS
• Use a pencil to mark the bracket location
GO TO STEP 6A
STEP IF
along its outside edges.
IF YOU ARE
YOU ARE
• Temporarily place the decorative duct cover
VENTING TO
VENTING
on top of the hood and extend the inner
THE REAR
VERTICALLY
portion to meet the ceiling.
(Straight-Up)
• The duct cover should be level and align with
marks for bracket.
• Remove the duct cover.
• Place bracket against marked location and
mark the 4 screw locations.
• Drill 1/8" pilot holes in marked location.
• If pilot holes do not enter studs, enlarge the
holes 3/8" and install wall fastener anchors.
Drive screws into the fasteners to allow
anchors to expand against the wall material.
Remove the screws.
• Secure the bracket to the ceiling and wall
with wood screws and/or wall fastener
screws.
GE Monogram at
Call 1-800-667-8721 anywhere in the US and Canada
:: com
.
rangehoods
is a division of
Installation
36" Vent Hood
accessories
::
kitchen
U N L I M I T E D
- www.rangehoods.com
Duct
Work
9