Step 8 Install Decorative Duct Covers; Step 9 Install Hood - GE Monogram ZV1050 Installation Instructions Manual

STEP 8 INSTALL DECORATIVE DUCT COVERS

Pretap
2 Screw
Holes
(One
On
Each
Side)
Top Duct
Cover
• Pretap or drive decorative screw into the screw holes
on the support frame. This will make screw installa-
tion easier.
• Separate the two decorative duct covers.
• Select the inside cover (top), which has two screw
holes in the top.
• Slide the decorative duct cover over the support
frame and push to the ceiling.
• Attach to the hood support at the top with 2 supplied
decorative screws.
• Locate the 3rd decorative screw in the hardware
package. Set aside.

STEP 9 INSTALL HOOD

Note: AT LEAST THREE PEOPLE ARE REQUIRED
TO COMPLETE THIS INSTALLATION!
• Lift the hood up to the support frame. Carefully
align the hood mounting holes to support frame
holes, and at the same time, the hood duct connector
into the duct.
• Install screws through the hood and hood support.
• Check hood level in both directions.
• Check to be sure that the duct is positioned over the
hood connector.
• Seal the duct connection with duct tape.
Note: Do not drive screws through this duct connec-
tion. Doing so will prevent proper damper operation.
Installation Instructions
Install Screw on
Each Side
Top Duct
Cover
Top Duct
Cover
Bottom Duct
Cover
• Slide the lower decorative duct over the installed
upper duct and push to the top, keeping the bottom
slotted hole to the left.
• Install the decorative stop screw in center hole of
upper (inner) duct cover. The decorative screw will act
as a stop screw and prevent the lower decorative duct
cover from sliding down.
CAUTION:
The stop screw must be installed.
Failure to do so could result in personal injury or
damage to the duct cover.
PRUDENCE –
place, afin d'éviter les blessures ou d'endommager le
capot antipoussière.
11
Bottom Duct Cover
Stop
Install Stop
Screw
Screw in Hole
of Upper (Inner)
Duct Cover
La vis supérieure doit être en
Bottom
Duct
Stop Screw
Cover
Install
4 Lock Washers
and 4 Machine Bolts
Apply Duct Tape
to Seal Duct
Connection